壓片機

Plastics, elastomers and other materials
Carver has developed the following three presses which are specially configured to perform the compression molding of test plaque or bar specimens of Type I, II, III or IV polyethylene and other thermoplastic resins. The procedure is in conformance with ASTM Method D 4703, Procedure C. The presses are equipped with eating/cooling platens and a programmable digital controller which has a heating/cooling loop for each platen and built-in program for the required 15°/minute ±2°C cooling rate.

※CMG 30H-12 ASTM Model B, 30 tons Floor standing, four-column, automatic press with heating/cooling platens and programmable controller.
※No. 4391-ASTM Model 12-12H-ASTM, 12 tons Benchtop, four-column manual press with heating/cooling platens and programmable controller.
※No. 4393-ASTM Model AutoFour/15P-ASTM, 15 tons & No. 4394-ASTM Model AutoFour/30P-ASTM, 30 tons